Output has too many oscillations using Tyreus-Luyben tuning parameters?

3 次查看（过去 30 天）
Catherine Smith
Catherine Smith 2018-11-2
编辑： Stephan 2018-11-3
I am trying to re-create these two figures from my process controls textbook:
These graphs were creating by using Tyreus-Luyben tuning parameters where y is the output and u is the input. My graphs are as follows:
My lines for the P and PI controllers are correct in both graphs, as well as my line for u for the PID. However, my PID y line (-.- line on both graphs) is oscillating too much, and I'm not sure how to adjust this. I've tried changing the value of b on my set point from 1 (keeping c=0), but this changes my u graph. My parameters & set-up are as follows:
kcu = 10 Pu = 6.2
Any thoughts on how to fix this would be greatly appreciated!

请先登录，再回答此问题。

回答（1 个）

Stephan
Stephan 2018-11-3
编辑：Stephan 2018-11-3
Hi,
is it correct that you use a 2DOF PID Controller? You dont use the second input port. The 2DOF works with weights for both inputs. Due to this fact the internal calculation is not the same as it is by using standard PID. I guess this is the problem you have.
I recommend either to use the second input port as shown in the documentation or use the normal PID Controller, what seems more problably to me, since you use an example from a book.
Best regards
Stephan

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Tuning 的更多信息

标签

产品


版本

R2018a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by