readVoltage() reading only 0 or 5

10 次查看(过去 30 天)
From an Arduino Mega I am outputting 0,1,2,3,4 volts using writePWMVoltage function (at D13), then I connected D13 to A0 for readVoltage. In theory, I am supposed to get 0,1,2,3,4V from A0, but I am only getting values 0 or 5 from A0. I already checked D13 is outputting correct values by measuring with DMM.
Am I wiring something wrong? Why is this happening? Any help is appreciated :)
  2 个评论
Gun Min Song
Gun Min Song 2018-11-7
This is the code I used for this experiment ----------------------------------------------
clear
clc
a = arduino
for i=0:4
writePWMVoltage(a,'D13',i)
voltage(i+1) = readVoltage(a,'A0')
pause
end
writePWMVoltage(a,'D13',0)
voltage(6) = readVoltage(a,'A0')
Walter Roberson
Walter Roberson 2018-11-8
https://www.mathworks.com/help/supportpkg/arduinoio/ref/writepwmdutycycle.html
Try setting the duty cycle higher in case it is returning to base before you can read it.

请先登录,再进行评论。

回答(1 个)

Rohan Kale
Rohan Kale 2020-2-14
In my understanding you are trying to read the DC voltages from the PWM waveforms generated on D13. Your code sequence seems to be alright. However, the hardware setup is where the problem is originating. In theory, the DC i.e. mean voltage, can be changed by changing the PWM duty cycle. I think the readVoltage API is just picking up the instances where the waveform is either a LOW or a HIGH, that's why you are reading either 0V or 5V. In order to read DC voltages correctly from the waveform, you may want to insert an RC filter between the PWM and analog pins. The RC filter will essentially increase the decay time as the capacitor would now discharge slowly. Try varying time constant of the circuit, may be keep it as 0.1 seconds. This should probably solve your issue.

类别

Help CenterFile Exchange 中查找有关 Arduino Hardware 的更多信息

标签

产品


版本

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by