How to set initial condition y(1)=1 in solving ODE using Simulink?

10 次查看（过去 30 天）
Yugal Maheshwari
Yugal Maheshwari 2018-12-23
评论： Yugal Maheshwari 2018-12-30
Can anyone guide me how can I set initial conditions for ODE in Simulink. It is easy to set Y(0)=0 or 1 in integerator. How to set Y(1)=1 in integrator.
I wanna solve dy/dt= (2/t) y , where y(1)=1 as initial condtions in Simulink.
  2 个评论
Aquatris
Aquatris 2018-12-26
If y(1) = 1 is your initial condition, it means your starting "time" is 1. Why not just set the integrator initial to 1 and offsett the time value whereever it appears in your equations?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Akshay Khadse
Akshay Khadse 2018-12-28
As Aquatris mentioned, the Start Time for simulation should be specified as 1 from the Configuration Parameters.
Then, you can specify the initial condition using any of the following methods:
1) Specify the Initial condition in the Integrator block parameters as 1. OR
2) Use Simulink.BlockDiagram.getInitialState as follows
x0 = Simulink.BlockDiagram.getInitialState(gcs);
x0{1}.Values.Data = 1;
Please refer the following documentation page to know more about the Simulink.BlockDiagram.getInitialState
https://www.mathworks.com/help/simulink/slref/simulink.blockdiagram.getinitialstate.html

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by