Averaging a signal at periodic intervals in Simulink
10 次查看(过去 30 天)
显示 更早的评论
I am trying to compute the average of a signal at periodic intervals. The signal is sampled at some rate say 0.1s, i want to compute avegare after every one second in simulink. I tried to integrate the signal over every second and then multipy it one second to get an avg value of signal. This method is not valid as the integraor is causing my function to blow up.
Please share any possible methods, Thanks.
0 个评论
采纳的回答
更多回答(1 个)
Jim Riggs
2019-2-15
In my mind, the easiest way to do this is to create a Matlab function to do it, and embed the function into a Matlab block in Simulink. It's a lot harder to do this kind of thing in Simulink because of the complex logic involved. (Stateflow helps a lot)
Make a matlab function that stores the signal in a circular buffer. Once you have enough samples in the buffer, you can output the average value over the N=10 samples. You can make the code so that it only outpus a new value every 1 second, or it can output every 0.1 s. (i.e. a "sliding average" ) using the 10 most recent samples.
4 个评论
Jim Riggs
2019-2-16
编辑:Jim Riggs
2019-2-16
Here is a sample output for a linear ramp test case:
This is a 0.1 sample rate, Navg = 10 and Nout = 10.
This is for Navg = 10 and Nout = 5
And this one is Navg = 10 and Nout = 2
Notice how they all have a 10 sample delay at the start.
Notice also that this test case runs at 0.1 time step for 10 seconds, and therefore generates 100 calls to the WindowAverage function. I set the buffer size to 50 in the function to verify that it wrapped correctly back to the start when it reaches the end.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Signals 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!