Signal Propagation in switch port

1 次查看（过去 30 天）
Moorthy
Moorthy 2012-7-27
Hi
I am using Matlab R2009b. I am trying to take all the signal names from the particular subsytem. I set the signal propagation as "on". The Mux which is connected to the subsytem which gives all the input signals but if the mux present inside the subsytem, then i am not able to receive the signal names outside of the subsytem.Because the mux signals are connected to switch port. Please let me know if you have any solution to get all the signal names.
Regards Moorthy Ka

请先登录，再回答此问题。

采纳的回答

Ryan G
Ryan G 2012-7-30
This sounds like you are using a mux like a bus, which doesn't always work as intended. See here.
Ideally you should use a bus creator block instead as this will allow you to better manage your signals.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Signal Attributes and Indexing 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by