Embedded Coder for C2000
显示 更早的评论
I've built a very simple model in which a counter is written to DAC-A on the F28379D LaunchPad. I expect to see a ramp at the appropriate pin on the board but there's nothing. I simple C program works correctly. Has anyone tried this?
My suspicion is that the DAC is not being enabled because when I inspect the generated code I don't see evidence of the DACOUTEN register being written to.
Thanks for any suggestions.
Regards,
Richard
采纳的回答
更多回答（3 个）
Venkatesh Chilapur
2019-3-19
0 个投票
Hi Richard,
Attached is the model which i found to be working for DAC-A. The model is created in 2018b version of MATLAB.
I found it working in both interrupt and periodic step time scenario. To get a view of ramp signal I found we need to work with high sample rate else we may not be able to make out the Ramp signal generated. You can either enable periodic/interrupt based approach to test the DAC block. Comment the other implementation which is not used in the model.
The perodic step time is set to 1ms which could give a good ramp signal. The interrupt runs still tight in usec scale. Be sure to tap the correct pin the launchpad for DAC output.
Hope this helps.
Regards,
Venkatesh C
linda xie
2019-4-11
0 个投票
您好
如果我的计算机无法连接到Internet，是否可以安装C2000硬件支持包？
Venkatesh Chilapur
2019-4-12
0 个投票
Yes, along with 'install' option for the support package, we also provide 'download' option.
That should help you to download the package and use it for offline install.
类别
在 帮助中心 和 File Exchange 中查找有关 Deployment, Integration, and Supported Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
