how to turn back into a loop after using Break command in the loop

1 次查看（过去 30 天）
Enez Furkan Cihan
Enez Furkan Cihan 2019-7-20
回答： Walter Roberson 2019-7-20
I wanna use 'break' command in a loop, when it goes out of the loop, I want it turn back into the loop. Is there a way to make it happen?
Thanks in advance
  3 个评论
显示 1更早的评论
Enez Furkan Cihan
Enez Furkan Cihan 2019-7-20
Both, assume I have 10-bit binary matrix vector, by the help of for loop, I want those bits to be sent bit by bit. I used for loop but you know it's just giving me the latest bit. So that I thought, For each iteration, I'd use break command and go out of the loop then send the bit to where it must go. Then come back to the loop and continue where the loop iteration was. Hope I've expressed well.
Guillaume
Guillaume 2019-7-20
I used for loop but you know it's just giving me the latest bit
Then ask help on fixing that problem. Typical case of XY problem.
Start a new question, explaining a lot better what it is you're trying to, with examples. Show us the relevant part of your code and if you get any error, the full text of the error.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

KALYAN ACHARJYA
KALYAN ACHARJYA 2019-7-20
编辑：KALYAN ACHARJYA 2019-7-20
Suppose you create a custom function to read the individual bit. like as follow-
%#Read the data
function bit_out=data_bit(i,j)
mat_data= %input logical matrix
bit_out=mat_data(i,j);
end
Next call the function for different values of i,j
%# Call the read data and send
data=data_bit(i,j);
%send data
%Change i,j, you may required loop and do again
Is this you are looking for? or look at Return funtion also
Walter Roberson
Walter Roberson 2019-7-20
No, there is no way to do that in the way stated. Once a loop is exited, the only way to get inside it again is to start it over.

类别

在 Help Center 和 File Exchange 中查找有关 Loops and Conditional Statements 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by