FFT is not showing the the signals I have created.

2 次查看（过去 30 天）

显示更早的评论

Francisco Márcio Dos santos 2019-7-23

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/473061-fft-is-not-showing-the-the-signals-i-have-created

回答： Pravin Jagtap 2019-8-5

FFT fault.PNG

Hi,

Could you please help me with it?

FFT is not showing the the signals I have created, consequently It is not showing the graphs.

Best regards,

Francisco

3 个评论
显示 1更早的评论隐藏 1更早的评论

Pravin Jagtap 2019-8-2

Can you provide your signals ?

Francisco Márcio Dos santos 2019-8-2

I don’t know how to do it. I have a simulation in simscape, but I haven’t work on simulink doing this before. Then I am lost how to make the program to show the FFT and DFT. Do you have any tip about what to do?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Pravin Jagtap 2019-8-5

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/473061-fft-is-not-showing-the-the-signals-i-have-created#answer_386179

Refer following documentation link for ‘powergui’ block, https://www.mathworks.com/help/physmod/sps/powersys/ref/powergui.html?s_tid=srchtitle

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

类别

Signal Processing Signal Processing Toolbox Spectral Analysis Spectral Measurements

在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by