Save an output each simulation
10 次查看(过去 30 天)
显示 更早的评论
Hi, I built a model in simulink, wich is feed with a variable input using this code:
mdl = 'PSDfaulty';
x = [0.8:0.01:0.95];
for i = 1:numel(x)
set_param([mdl '/FrontFault'] , 'Value' , num2str(x(i)));
simout = sim(mdl);
end
and it works perfectly, now I need to save in the workspace the output of the model for each simulation, if possible by modifying the code. Im using a simout block but it only saves the last value, Any advice? Thanks.
6 个评论
Walter Roberson
2019-7-31
I am not certain but I suspect that you will need 3 outputs from the sim() command and that all of the interesting values are muxed together in the third output. However at the moment I am not sure what datatype that third output would be or how the values would be arranged for it.
采纳的回答
Fangjun Jiang
2019-7-31
In your model, you have a "To Workspace" block logging four signals and writing to a workspace variable "simout". Of course, the workspace variable "simout" is going to be over-written in every for-iteration.
In your script, your also specified a return variable "simout" when calling sim(). This is probably a unintended mistake. Not to mention the name conflict (both are called simout but they are logging different contents). simout=sim() can return values but the contents are dependent on the "Data Import/Export" setting in the model Configuration Parameters. You can't use [out1, out2, out3, out4] = sim(mdl) to expect to return those four signals that you want to log.
I suggest the following and you can take a look at one cell of "Loggings"
mdl = 'PSDfaulty';
x = [0.8:0.01:0.95];
for i = 1:numel(x)
set_param([mdl '/FrontFault'] , 'Value' , num2str(x(i)));
sim(mdl);
Loggings{i}=simout; % simout is the variable name specified in the "To Workspace" block
end
3 个评论
Fangjun Jiang
2019-7-31
编辑:Fangjun Jiang
2019-7-31
No. You need to keep the "To Workspace" block but not to return variable in sim() call as indicated in my answer. You got 16 cells because "simout" already exists in workspace but all cells are the same.
To acchieve variable name as acc1, acc2, ... (not recommended), you could add a set_param() line in your for-loop to change the variable name of the "To Workspace" block. Then you just need to run the loop with sim(), no need to copy to annother variable e.g. Loggings.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Model Verification 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!