Error using Simscape Eletrical - Boost Converter component
显示 更早的评论
This is my first time using Simscape. While trying to simulate a model which has two Boost converter blocks, the following error appears on the diagnostic viewer:
"Error compiling Simscape network for model Tentativa1.
Caused by:
'D.p' is not defined in this scope. In ee.semiconductors.converters.dcdc_converters.boost.elec"
The model is the one below:
I wanted to know why is this error occurring, and what do I have to do in order for me to be able to simulate. Any help on this is very much appreciated.
1 个评论
Janosch Marquart
2019-8-12
Hi Eduardo
Is D.P. a variable you are using? Then it could be that this variable is not declared properly or it is only accessible in a subcircuit. Hard to tell without the model.
Could you share the model?
In general, it is a good approach as Boris mentions in his answer, to break down the model to one converter to simplify it. Then figure the problem out there and add the second model again.
Cheers,
Janosch
采纳的回答
Sabin
2019-8-12
2 个投票
I was able to reproduce the problem. It seems that for the Boost Converter block there was a build issue. If you change the default value for any parameter in both Boost Converters and press apply the error will dissapear. Moreover, I've noticed that you need an Electrical Reference connected to the ref- terminal of the Controlled PWM Voltage.
Hope that helps.
更多回答（1 个）
boris vuleta
2019-8-11
0 个投票
Hi! If go to matlab site and look for some docum about simscape and generally simulink, you'll find an instruction to start in steps. Remove one converter find some info about elements you are using and how to configure the simulation www.mathworks.cn › simscape_ug Simscape User's Guide - MathWorks You don't need to read it all just some inf about physical networks... Good luck ?
社区
类别
在 帮助中心 和 File Exchange 中查找有关 Converters (High Power) 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
