Two Errors Happen When Running R2019a Instead of R2018a on ADI RF SOM Board

2 次查看（过去 30 天）
Chao-Hwa Chen
Chao-Hwa Chen 2019-8-15
回答： Prasad Parameswaran 2020-2-25
I have run the tones project successfully in MATLAB R2018a. I try to run the same thing in R2019a. I replaced the ADI RF SOM ARM-FPGA TX/RX blocks with AD936x TX/RX blocks. While running the project, the following errors happens:
Error occurred while executing External Mode MEX-file 'ext_comm': ExtTargetPktPending() call failed while checking for target pkt
Error occurred while executing External Mode MEX-file 'ext_comm': ExtSetTargetPkt() call failed on CLOSE. Ensure target is still running
Below is the screen shot. Could you tell me how to change the settings such that it does not happen again?
screenShotADIRFSOM.png

请先登录，再回答此问题。

回答（1 个）

Prasad Parameswaran
Using the "Upgrade Advisor" may resolve the issue. Do refer the below link for more information:
https://www.mathworks.com/help/releases/R2019a/simulink/ug/consult-the-upgrade-advisor.html

类别

在 Help Center 和 File Exchange 中查找有关 Install Products 的更多信息

标签

产品


版本

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by