obtain "gca" and "gcf" from an existing fig file, which was generated by "plotyy"

Question

Dingguo Lu 2012-9-13

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/48135-obtain-gca-and-gcf-from-an-existing-fig-file-which-was-generated-by-plotyy

I plan to modify the exiting fig and therefore, the "gca" and "gcf" information is needed. but get(gca) is only valid for the first layer of the plot. But I also want modify the second layer.

so how can I get information for both layers, i.e., gca1 and gca2?

Thanks

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Walter Roberson 2012-9-13

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/48135-obtain-gca-and-gcf-from-an-existing-fig-file-which-was-generated-by-plotyy#answer_58775

在 MATLAB Online 中打开

 FigureNumber = openfig('TheName.fig');
 axes_handles = findobj(FigureNumber, 'type', 'axes');

2 个评论
显示无隐藏无

Dingguo Lu 2012-9-14

Thanks first!

However, FigureNumber = openfig('TheName.fig'); will move one layer from original place. Is there any way to correct it?

Walter Roberson 2012-9-14

openfig() will create a figure. Figures are never nested. The created figure will be at exactly the same layer as it was when it was created. The only difference may be in the figure number.

请先登录，再进行评论。

Answer 2

per isakson 2012-9-14

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/48135-obtain-gca-and-gcf-from-an-existing-fig-file-which-was-generated-by-plotyy#answer_58779

编辑：per isakson 2012-9-14

在 MATLAB Online 中打开

The doc (R2012a) says:

    [AX,H1,H2] = plotyy(...) returns the handles of the two axes created
    in AX and the handles of the graphics objects from each plot in H1 and
    H2. AX(1) is the left axes and AX(2) is the right axes.