Using triggered subsystem with either - need a reset but how?
2 次查看(过去 30 天)
显示 更早的评论
Hey guys,
I need to use a triggered subystem to detect flanks (pos and neg) and calculate the time difference between these and then pass the value on to calculate the speed which will go into a PI controller and herefore i need also the the values (in my case it will be 0 - when no more flanks are detected) when the system is not triggered anymore.
But my problem is that the triggered subsystem starts when the flanks starts and hold the last value when no flanks are coming anymore.
I need the 0 at the beginning and the 0 at the end because with this i would pass on a wrong value to the controller.
![2019-10-28_17-01-32.png](https://www.mathworks.com/matlabcentral/answers/uploaded_files/245411/image.png)
I build an example so u can understand what I mean.
Thanks in advance. =)
0 个评论
回答(2 个)
Ganesh Regoti
2019-11-6
Hi,
There is no such feature of resetting the block states in triggered subsystem. It is also stated in the documentation here.
Instead you can use Enabled Subsystem block if it suits your model as it has the resetting of states option. You can refer the following link
Hope this helps!
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!