F28379D-Simulink data monitoring: PWM signals

9 次查看（过去 30 天）
Praveen Kumar
Praveen Kumar 2019-10-30
评论： Mohammad Qaza 2023-12-27
Hi,
I am learning to use TI F28379D interface with Simulink. I saw examples of data monitoring where voltage, currents data are monitored in simulink using external mode and C2000_host_read_12M example (not clear how works).
I would like to generate a PWM signal of certain freq and is it possible to monitor it in simulink? Since ePWM block doesnt have any output pin, I cant connect any scope. I could monitor the input in external mode.
  1 个评论
Mohammad Qaza
Mohammad Qaza 2023-12-27
Hi, I'm trying to do the same. have you been able to figure this out??
Thanks in advance.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Venkatesh Chilapur
Venkatesh Chilapur 2019-11-4
Hi,
Please check the below link for an idea on Host-Target SCI setup.
https://www.mathworks.com/matlabcentral/answers/419321-what-is-the-idea-behind-data-processing-for-sci-communication-in-dc-dc-buck-converter-example
ePWM block act as driver block such that it can generate the code and run the same on the target. It has no simulation capability to show what output pattern will be generated. We can only see this output on a PWM pin on the hardware using DSO.
HTH,
Regards,
Venkatesh C

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Pulse width modulation (PWM) 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by