What are "gap ports" in Simulink?

2 次查看（过去 30 天）
Zachary
Zachary 2020-1-20
评论： Zachary 2020-1-27
I am trying to convert a Subsystem to a Subsystem Reference, but I get this error message. What are "gap ports"? I can't find any mention of it on MATLAB Documentation or MATLAB Answers.
Capture.PNG

请先登录，再回答此问题。

采纳的回答

Payas Bahade
Payas Bahade 2020-1-24
Hi Zachary,
This is a known issue and the error is due to the number of port handles and the number of port blocks inside the Subsystem being unequal.
To get rid of the error, both port handles and port blocks have to be equal in number.
Hope this helps!
  1 个评论
Zachary
Zachary 2020-1-27
In the end, I was unable find the mismatch between port handles and number of port blocks. Instead of using the toolstrip UI conversion, I manually copied the contents into a new Blank Subsystem, saved the file, and configured a new Subsystem Reference block to point to this new file.
If this post is viewed by others, I might have been able to troubleshoot by reading the block's 'PortHandles' and 'Ports' properties...
port_handles = get_param(gcb,'PortHandles')
ports = get_param(gcb,'Ports')
...and altering the incorrect values with set_param, but I didn't try this so no promises.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Subsystems 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by