Problem with Simulink and Arduino Uno Board

Question

Vasavi Sai 2020-1-30

编辑： Arun Kumar 2020-1-31

Hello...

I programmed Arduino using Simulink blocks. It is working fine but every time it should connect to Simulink to work.

When I close the Simulink the Arduino is not working, in this case, I can't keep my PC ON with Simulink to run the Arduino.

Is there any solution to use the only Arduino with 12V adaptor after uploading from Simulink.

Thank You

Answer 1

Arun Kumar 2020-1-30

编辑：Arun Kumar 2020-1-31

Hi Vasavi,

I think you are running the model in "External Mode" which requires Simulink model to be running in order to run the program on the target.

To independently run the code, use "Build, Deploy & Start" option available under Hardware tab. Refer this doc page:

For older releases, follow this documentation: