How to perform handshaking operation
5 次查看(过去 30 天)
显示 更早的评论
Hello, my project is to transmit data to the analog output pin of MCC USB 205 DAQ. From the DAQ the data goes to ADI Board for further process. To increase the speed of data transmission I am using a C mex file to transmit data. Now I want to implement handshaking operation to transmit the data. I have 3 data's to transmit (a,b,c) based on the rising edge and falling edge of clock. I am totally new to this, can anybody give suggestions like how to do it, where to start with, or any example code or documents.
0 个评论
采纳的回答
Walter Roberson
2020-2-27
Unless the clock rate is very slow, there is no realistic way to monitor the clock edge at the MATLAB level in order to determine when to transmit the signal.
This is the sort of task that you use an external device to handle the timing and signal transmission. Some daq boards can handle it: you command them with trigger information and appropriate response and let them run independently.
9 个评论
Walter Roberson
2020-3-2
I need to transmit 1x256 double data (it corresponds to image pixels) to analog output pin 0
You need to transmit the bit sequence corresponding to the IEEE 754 Double Precision representation of each pixel?? If so, in what bit order?
Or for each pixel, you need to transmit a single voltage that corresponds to (say) pixel-value/(2^16) or pixel-value/256 of full voltage, and it is acceptable if the remote end does not exactly reconstruct the same voltage?
Or... ??
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Troubleshooting in Data Acquisition Toolbox 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!