How do you connect a thermistor block in a Wheatstone Bridge Setup in Simulink?

4 次查看（过去 30 天）
Anthony
Anthony 2012-10-19
I am trying to setup a wheatstone bridge in Simulink but for some reason the terminals won't connect to the other resistors.
Steps:
1. Tried connecting the terminals directly to the other resistors but there is no connection i.e red dashed line with white circle at the end.
2. Searched the help page but couldnt make sense of it. I said something about using a convection heat transfer block and ideal temperature source block.
Can anyone suggest a solution?

请先登录，再回答此问题。

回答（1 个）

Sachin Ganjare
Sachin Ganjare 2012-10-19
Refer the link below:
http://www.mathworks.com/matlabcentral/fileexchange/37723-wheat-stone-bridge
Hope you will find it useful!!!
  1 个评论
Anthony
Anthony 2012-10-19
Thanks Sachin, For that very circuit I am trying to have a Wheatstone Bridge with 1 Thermistor replacing a resistor. I have tried to connect the thermistor as you would a resistor but it doesnt work. The help menu said use a convection heat transfer block and an ideal temperature source block but I dont know how to do it.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Encoders and Transducers 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by