Unable to Run Arduino Nano on External Mode

4 次查看（过去 30 天）

显示更早的评论

Jason Wang 2020-3-28

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/513500-unable-to-run-arduino-nano-on-external-mode

评论： Sylvain 2022-1-18

https://www.mathworks.com/matlabcentral/answers/502313-simulink-unable-to-upload-to-arduino-nano-3-0-linux

From Here onward it works for the simulink, but I am unable to run in external mode and try to "Monitor and Tune"

Deploying the code onto the arduino works. And even on an Arduino Uno it works. But I run into this issue on Nano

This is the error I am getting. I've tried the method used here but it doesn't work.

https://www.mathworks.com/matlabcentral/answers/426930-arduino-nano-won-t-work-with-simulink-arduino-support-package

Jason

3 个评论
显示 1更早的评论隐藏 1更早的评论

Caren dudy 2021-11-14

I am having the same problem with my arduino uno (clone). I have tried to change the baudrate that has been told but it did not work , im still getting the same error as you do. Have you found any solution ?

Sylvain 2022-1-18

I have faced a similar issue (though I do not rememeber the error message): the code was ok to be build and deployed but could not run with the tune&monitor mode. I found out it was a memory issue: Tune & Monitor add too much code to be supported by the Atmega368p. I upgraded to an arduino Due and it worked fine.

请先登录，再进行评论。

请先登录，再回答此问题。