清空筛选条件
清空筛选条件

How to export the values of the radiation pattern from antenna designer to workspace

11 次查看（过去 30 天）
EN
EN 2020-3-31
评论： alan cheville 2022-4-10
When using Antenna designer we can plot the elevation pattern and impedance etc. What is the easiest way to extract the individual values from these plots
in order to do further processing on them in Matlab?

请先登录，再回答此问题。

采纳的回答

Shashank Kulkarni
Export your design into a MATLAB script. Then you can pass a LHS to the pattern function to get the maginitude of the directivity to the workspace.
I hope this helps.
Regards,
Shashank
  4 个评论
显示 2更早的评论
Jeffrey Lytle
Jeffrey Lytle 2021-3-2
Using, a=patternElevation(antennaObject, plotFrequency); I am able to get the El and AZ patterns, how do I get the 3D pattern?
alan cheville
alan cheville 2022-4-10
I didn't know what an LHS was so had to figure this out on my own. Basically if you export the script then modify the last line and past the code below into the bottom of the script you can generate the pattern:
[D,phi,theta] = pattern(antennaObject, plotFrequency) % Modify the last line to export parameters
phi = phi/180*pi+pi; % change to 0 to 2*pi rather than -pi to pi
theta = theta/180*pi + pi/2; % change to 0 to pi rather than -pi/2 to pi/2
[Phi Theta] = meshgrid(phi,theta);
RdB = (D-min(D))./(max(D)-min(D)); % normalize to between 0 and 1
X = RdB.*sin(Theta).*cos(Phi);
Y = RdB.*sin(Theta).*sin(Phi);
Z = RdB.*cos(Theta);
figure;
surf(X,Y,Z)

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Get Started with Antenna Toolbox 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by