Hi I want to generate a signal as a load follow input signal for 80%-50%-80% at 10% per minute for a nuclear power plant control system on simulink? I would be glad for help because i am stucked at this stage?
2 次查看(过去 30 天)
显示 更早的评论
The signal is attached. Thank you
2 个评论
采纳的回答
Birdman
2020-4-1
Run the attached model. I used Signal Builder block to create the input signal.
13 个评论
Birdman
2020-4-1
In the attached figure explanation1, you see that you can set the T and Y value of that specific point by either changing the value in T and Y edit field, or by just simply dragging that specific point.
In the attached figure explanation2, you can create a new piece of line by simply dragging upwards or downwards the circled line and then again, you can set its starting and end points.
更多回答(0 个)
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!