When I was doing PIL with matlab2018b and TMS320F28377D, the simulation went wrong

1 次查看（过去 30 天）

jinyu wang 2020-5-6

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/523318-when-i-was-doing-pil-with-matlab2018b-and-tms320f28377d-the-simulation-went-wrong

The errors reported are as followsJTAG and ccs can work normally, I can also download the program directly from MATLAB to 28377d.

The errors reported are as follows：

The timeout of 10 seconds for receiving data from the rtiostream interface has been exceeded. There might be multiple reasons for this failure. You should: (a) Check that the target hardware configuration is correct, for example, check that the byte ordering is correct. (b) Confirm that the target is running. (c) Consider the possibility of application run-time failures (e.g. divide by zero exceptions, incorrect custom code integration, etc.). Note (c): To identify possible reasons for the run-time failure, consider using SIL, which supports signal handlers and debugging. If you cannot find a solution, consider using the method setTimeoutRecvSecs of rtw.connectivity.RtIOStreamHostCommunicator to increase the time value.