seperating integer values using if block in simulink

1 次查看（过去 30 天）
kumaresan
kumaresan 2012-11-3
I have integers [1 2 3 5 6 7 8 9 10] and function f(x) and g(x), I specified those ingeters in a constant block labled x. In the command window I specified x=[1 2 3 4 5 6 7 8 9 10]. another variable y is specified as 5 in the command window, y=5. For integers x=>5 function f(x) is computed and for integers x<5 function g(x) is computed. I used the if block to perform this condition. when i run the simulation this error comes up.
Error in port widths or dimensions. Output port 1 of 'model/constant,x2' is a one dimensional vector with 10 elements.
i think the if block could not take all the values at the same time.
how do i go about this? is there any other way to do this?
thank you. your guidance is very much appreciated.

请先登录，再回答此问题。

采纳的回答

Raju Purohit
Raju Purohit 2012-11-4
I cannot be sure unless you post your model but I think the problem arising in your model is by this: in the block parameters of "If block" under "If expression", you have used u1 >= 5 (ie., x >= 5) which is incorrect. x is a vector with the order 1x10, while on the right hand side is 5 which is a 1x1 integer. MATLAB cannot compare the two dimensionally mismatching variables.
Instead, you need to use u1(i) >= 5, where i can be anywhere between 1 and 10, in which case u1(i) will be a 1x1 variable and can be compared to 5.
Hope this helps.
  3 个评论
显示 1更早的评论
Raju Purohit
Raju Purohit 2012-11-6
I think you have to reconsider your logic. You can set only one condition for an "if" block. But in your case, you have 10 simultaneous conditions, and thus you have to build logic accordingly. What I am guessing is that you want to send 10 integers 'one by one' and make the "if" block work accordingly. Can you explain me what exactly you want so that I can be more helpful? Also, you uploaded image is barely readable.
kumaresan
kumaresan 2012-11-21
your guess is correct. I do want to send 10 integers 'one by one' and make the "if" block work accordingly. I want the if box to send the integers to the block based on my conditions which is >5 and <5. so what i want is for the 'if block' to recognise the integer, then if the integer is more then 5, it is sent to a subsystem and if its less then 5 its sent to another subsystem for further calculations. For starters I'm only using 10 integers later on i will use more integers.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Schedule Model Components 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by