Run Simulink continuously with NI-DAQ

4 次查看（过去 30 天）
cyberdyne
cyberdyne 2011-4-12
Hi,
I need to run the acquisition by DAQ continuously with external analog input.
I tried with Analog Input block from Data Acquisition Toolbox (it finds DAQ automatically and allows to set Sample rate, channels, etc...), but at stop time, obviously, acquisition turns off.
In Real-time windows target (analog input block), if i check among Data Acquisition Board there's not my DAQ (NI-6020E).
How can i make it acquire signals by DAQ?

请先登录，再回答此问题。

回答（2 个）

Arnaud Miege
Arnaud Miege 2011-4-12
If the Data Acquistion Toolbox is fast enough for you, you can set the stop time to Inf, and it'll keep going until you manually stop it.
HTH,
Arnaud
  4 个评论
显示 2更早的评论
cyberdyne
cyberdyne 2011-4-16
Ok. Therefore is a scope options. So, without scope, can i say that data flows fully during simulation?
Arnaud Miege
Arnaud Miege 2011-4-16
Yes, it should do, unless you run out of memory or the buffer gets full. I imagine that the data coming from the DAQ card fills up a buffer which gets read by the software.

请先登录，再进行评论。

Kaustubha Govind
Kaustubha Govind 2011-4-12
For use with Real-Time Windows Target, you can only use boards that are in the Supported Hardware List.
If you don't see your device here, you can submit an enhancement request with Tech Support so your board can be considered for support in a future version of the software.

类别

在 Help Center 和 File Exchange 中查找有关 Hardware-in-the-Loop Simulation with Simulink Real-Time 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by