lookup table error in simulink

39 次查看（过去 30 天）
vishnuvardhan naidu tanga
评论： Sai Sri Pathuri 2020-6-2
Hello I am trying to model a 2D lookup table in simulink. I am calling the break points and table data from workspace. When i run it it shows an error as "the number of dimensions specified by the 'Table data' parameter (1) must match the 'Number of table dimensions' parameter value (2)." but when I check the table dimensions are table data: 1x9000 and break point 1 : 1x9000 and break point 2: 1x9000 all are same. But still I am getting this error. Please guide me through it.

请先登录，再回答此问题。

回答（1 个）

Sai Sri Pathuri
Sai Sri Pathuri 2020-6-2
Check whether you have set Number of table dimesions to 1, since your data is one-dimensional
  4 个评论
显示 2更早的评论
vishnuvardhan naidu tanga
vishnuvardhan naidu tanga 2020-6-2
yes i run the code. when i run the code the break points are updated from the data base. the error marks in break points are eliminated. But the system wont run because of the following error:
In block 'SH', the number of dimensions specified by the 'Table data' parameter (1) must match the 'Number of table dimensions' parameter value (2).
Sai Sri Pathuri
Sai Sri Pathuri 2020-6-2
Set Number of table dimensions (I highlighted it in above screenshot) to 1 in the dialog box, because your input is one-dimensional

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by