If Action Block that create a stairstep signal in simulink

2 次查看（过去 30 天）
Alberto Mora
Alberto Mora 2020-6-1
回答： Fangjun Jiang 2020-6-1
Hello,
I have two questions:
  1. I use a If Block to "cut" the signal and not perform some operations (not depicted below). Is it the right approach to use a "If Block" for interupt the signal and don't allow to perform some tasks by the model?
  2. However I notice that after the "If Block" the signal became discrete (see the plot below, where you can see a stairstep plot), even if before the "If Block" the signal was continous (see the plot below, where you can see a continous plot). How to convert again the discrete signal into a continous?

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang
Fangjun Jiang 2020-6-1
The "sample time" of the Constant block might have been set as "1" second.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by