Failed to load module 'canberra-gtk-module'

16 次查看（过去 30 天）
Joe Choi
Joe Choi 2020-6-3
编辑： Yash 2024-8-22
Before I install the MATLAB, I do the followings;
sudo apt-get install libcanberra-gtk-module
sudo apt-get install libcanberra-gtk-module:i386
At the end of the installation, the installer indicated that extra installation is needed.
It is looking for a supported c compiler for simulink
I clicked onn the supported compiler, error message
Failed to load module "canberra-gtk-module"
What is the solution?
  3 个评论
显示 1更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Yash
Yash 2024-8-20
编辑：Yash 2024-8-22
Hi Joe,
The message you are encountering is informational and has no effect on MATLAB. This issue is a known bug and has been acknowledged by MathWorks in the following bug report: https://www.mathworks.com/support/bugreports/1995075 .
To suppress these messages, you might need to set the environment variables. Kindly follow the steps mentioned in the following article: https://www-integ3.mathworks.com/help/releases/R2021a/matlab/matlab_env/remove-canberra-gtk-module-and-pk-gtk-module-messages.html
You can also refer to the following relevant MATLAB Answer: https://www.mathworks.com/matlabcentral/answers/479778
I hope this helps!

类别

在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by