How to change Simscape Multibody model parameter during simulation
1 次查看(过去 30 天)
显示 更早的评论
My multibody modle shall change length,mass,inertia of the rod during simulation. Is this supported in the Simulink
1 个评论
Ameer Hamza
2020-6-20
I don't think it is supported yet. I tried it some time ago, but simscape blocks didn't respond to that. Simsapce blocks are different as compared to normal Simulink blocks, so I guess there are some implementation differences. You may try it using event-listeners and set_param() as given here: https://blogs.mathworks.com/simulink/2013/01/25/accessing-block-data-during-a-simulation/.
回答(1 个)
Steve Miller
2021-6-7
Hi Mark,
There are variable solid blocks in Simscape Multibody.
- https://www.mathworks.com/help/physmod/sm/ref/variablebricksolid.html
- https://www.mathworks.com/help/physmod/sm/ref/variablecylindricalsolid.html
- https://www.mathworks.com/help/physmod/sm/ref/variablesphericalsolid.html
Their properties can vary during simulation.
You can also motion actuate a joint to change the separation of two frames during simulation.
--Steve
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Assembly 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!