Trouble interafcing FS300 SpecAn using USB interface and NI VISA 5.0.3 with Matlab

2011 4 28
2 个回答
回答已采纳
5 次查看（30 天）

0 个投票

HI, I'm stuck with a problem in interfacing the Rhode & Schwarz FS300 spectrum analyser to Matlab through NI VISA 5.0.3. I'm using Matlab 2011a. Create new Interface option in tmtool doesn't shows my instrument connected to the USB drive. The NI VISA interactive control shows my USB device, but listed as USB RAW. I beleive I need to get this listed as INSTR?
Any help ?
Thanks, Bala

请先登录，再回答此问题。

 采纳的回答

Ankit Desai
Ankit Desai 2011-4-30

0 个投票

If you plan to communicate with the instrument using low level SCPI commands, via VISA-USB object - it has to be of USBTMC (Test & Measurement) class i.e. the VISA Resource Address must end with ::INSTR.
However, if you plan to communicate with the instrument using the industry standards such as VXIPnP or IVI - you can use the USB-RAW VISA Resource Address. Here's more help on how to use these drivers in MATLAB.
Hope this helps,
-Ankit

更多回答（1 个）

0 个投票

It's working now! The USB interface to Fs300 and Sm300 instruments doesn't show up in the VISA software (both NI and Agilent). But SiScan from Rohde and Schwarz driver installation shows the USB connection and the required address to connect from tmtool. The driver installation requires a VISA software installed in the PC.

类别

在 帮助中心 和 File Exchange 中查找有关 Instrument Connection and Communication 的更多信息

产品

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by