How to draw only a part of a known curve?

9 次查看（过去 30 天）
ErikJon Pérez Mardaras
评论： ErikJon Pérez Mardaras 2020-11-25
I have made this
The blue plot, is a curve defined like this:
curve=[xco0 xco1 xco2 xco3 xco4 xco5 xco6 xco7 xco8;yco0 yco1 yco2 yco3 yco4 yco5 yco6 yco7 yco8];
Which each x and y components, are its known coordinates. Each one has a lot of values in it.
I also have pointA and pointB, which are points of the curve which coordinates are known:
pointA=[ax;ay];
pointB=[bx;by];
The issue here is that I would like to draw only the part of the curve that is between those two points, or to colour the curve as white the rest of the curve that is not between pointA and pointB, which is the same thing in fact.
How can I do that?

请先登录，再回答此问题。

回答（1 个）

Fangjun Jiang
Fangjun Jiang 2020-11-10
x=1:0.1:10;
y=sin(x);
index=and(x>3, x<6);
plot(x(index),y(index))
  10 个评论
显示 8更早的评论
Fangjun Jiang
Fangjun Jiang 2020-11-25
In this case, index=and(y>Ya, y<Yb) is sufficient. It is due to the fact that x values exceed Xb and then comes back. Same thing could happen to y values. It is a math problem, not a MATLAB problem. You need to consider different and all the cases of your curves.
Just like your figure illustrated, index1=and(y>Ya,y<Yb) gives you the area between two purple dash lines. index2=and(x>Xa,x<Xb) gives you the area between two orange dash lines. index=and(index1, index2) gives you the rectangel area between those four dash lines.
ErikJon Pérez Mardaras
ErikJon Pérez Mardaras 2020-11-25
Thanks for your reply.
But just because of that, I am looking for a general way of doing it, not a particular way that works only for a particular curve. Is there any?

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Fit Postprocessing 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by