simulation of LL fault in PV array

14 次查看（过去 30 天）
PRASHIK KAMBLE
PRASHIK KAMBLE 2020-12-3
回答： Shivam Gothi 2024-8-22
how to simulate short circuit between two points in PV array?

请先登录，再回答此问题。

回答（1 个）

Shivam Gothi
Shivam Gothi 2024-8-22
Hello,
The short circuit can be simulated in Simulink by using “breaker” block of Simulink. We can control the opening and closing of Breaker by passing external logical signal. When logic “0” is passed, the breaker contacts are open and when logic “1” is passed, the breaker contacts are open.
In order to create a short circuit across DC bus of PV array, connect the “breaker” across DC bus of PV array, as shown in the below figure.
The opening and closing of the breaker is controlled by the block named “Breaker closing command”. This blocks generates logical “0” for time (0 < t < 0.5s) and logical “1” when the time is greater than 0.5 seconds.
The voltage and current measuring blocks are also added to see the voltage and current data at the scope.
Below given figure shows the voltage and short circuit current, following a fault.
After fault, the DC bus voltage of PV array drops nearly to zero and step rise in current can be seen.
I hope this answers your query.

类别

在 Help Center 和 File Exchange 中查找有关 Circuits and Systems 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by