during the simulation following error is occured " the number of defined parameters, 11, does not match the number of parameters on the dialog which is 10"how can i remove this error?
显示 更早的评论
For S-function 'sfun_spssw_discc', the number of defined parameters, 11, does not match the number of parameters on the dialog of 'Power_PMSM_Drive_Diagram_complete/powergui/EquivalentModel1/State-Space', 10. These two values must be identical.
采纳的回答
Ryan G
2013-3-26
1 个投票
It sounds like you defined 11 parameters in the s-function and only put 10 in the dialog. You need to look at the s-function to determine which parameter you are missing and make sure you input your parameters in the right order.
更多回答（3 个）
Guillermo L
2013-7-3
Hi,
Using SLPS for orcad I'm getting the error:
For S-function 'slpsblk', the number of defined parameters, 0, does not match the number of parameters on the dialog of 'test1r2012bw32/SLPS/S', 11. These two values must be identical.
Inside the slps block I se the 11 parameters, [url=http://obrazki.elektroda.pl/3829826900_1372871041.jpg][img]http://obrazki.elektroda.pl/3829826900_1372871041_thumb.jpg[/img][/url]
but I don't no where else I have to config, I've been following tutorials, and the slps demos that come with orcad work.
I compare the modul parameteres dialogs(RC demo & my primitive test) and they are the same.
Thanks, Guillermo
kshama
2014-1-22
0 个投票
hii.. can this error b becoz of SLPS software? from where do i get this software?
yangfei wei
2022-9-19
0 个投票
i had the same problem. complier is not intelligent enough,u can close and restart matlab to solve the problem.
类别
在 帮助中心 和 File Exchange 中查找有关 Embedded Coder 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
