How to connect bus signal with different data size using multiport switch?
4 次查看(过去 30 天)
显示 更早的评论
Hi,
I have two subsystems, and I want to minimized the data size for the signal that is been transfered in between the subsystems. The following figure shows the ideal case. When Constant1 = 1, the first signal with size {1} is transmitted; when Constant1 = 2, the second signal with size {2} is transmitted; Unfortunately, there will be error pop-up regarding to data size mistmatching in this model, which is attached. How could I solve this error or is there other approach to minized this data size. Noted that the constant value should be constant during the simulation.
Regards,
Andy
0 个评论
采纳的回答
Mark McBroom
2021-1-4
I made a number of changes to your model, most importably was to remove mux blocks. Mux blocks should not be used. Use Vector/Matrix concat blocks to create vectors/matrices, use Bus Creater blocks to create buses.
更多回答(1 个)
Mark McBroom
2021-1-1
On the Multi-port switch block, on the Signal Attirbutes tab, check the box "Allow different data input sizes".
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Discrete 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!