How can two different sampling times can be handled in a control system simulation(on experimental setup)?

2 次查看（过去 30 天）
Praveen Manupati
Praveen Manupati 2013-4-15
In my control system design, the output sampling rate is higher than the input sampling rate and feedback is taken from the output(for controller design). when it is implemented in the SIMULINK, it works fine but when it is implemented on the experimental setup it shows the error that two different sampling rates cannot be handled at the same time. How should I handle this error?
The Error is : C:\Program Files\MATLAB\R2012b\toolbox\rtw\targets\rtwin\rtwin\rtwinlib.tlc line:43 column:38, the left-hand side of a. operator must be a valid scope identifier

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Dynamic System Models 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by