Highlight a specific contour level in contour plot?

24 次查看（过去 30 天）
Madan Kumar
Madan Kumar 2021-2-2
评论： Madan Kumar 2021-2-2
Hi,
I have a contour plot and I want to highlight only a selected contour level. How can I do it? I tried all techniques reported but no success.
my code is follows and I want to highlight contour only with levels equal to 0 (zero). Can anyone help me out. Thank you. I am using matlab2015a.
z=load('data.txt');z=round(z);
x=1:0.1:9.1;
y=80:0.5:115;
[C,h] = contourf(x,y,x);
colorbar;
thisH = findall(h,'Userdata',0.0);
set(thisH,'linewidth',5)

请先登录，再回答此问题。

采纳的回答

Bjorn Gustavsson
Bjorn Gustavsson 2021-2-2
The simplest way might just be to add an separate contour:
[C,h] = contourf(peaks(123));
hold on
emphasis_level = 0;
contour(peaks(123),[1 1]*emphasis_level,'k','linewidth',2);
HTH
  6 个评论
显示 4更早的评论
Bjorn Gustavsson
Bjorn Gustavsson 2021-2-2
编辑：Bjorn Gustavsson 2021-2-2
Yes. In my first example peaks has values safely above and below zero. In your example M has extreme-values exactly at zero. Then you will just not get a contour at that level, it might be a requirement that M has values above and below a contour-level to actually make a contour, think about this the way of a topographic map, for a contour to be meaningfull the topography has to be above that level on one side and lower on the other. My interpretation is that the reason you get no contour just at zero in your example is an unrelated problem to the highlighting question.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Contour Plots 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by