Low-cost video capture devices compatible with Image Acquisition Toolbox?

6 次查看（过去 30 天）
Clay
Clay 2013-4-24
评论： XING HU 2017-3-10
Hello,
I need to capture an analog video signal (via either coax, vga, or rca) using the image acquisition toolbox, and I'd like to do it without buying an expensive frame grabber if possible. I have seen the brands listed here for compatibility:
https://www.mathworks.com/products/imaq/supported/index.html
but it doesn't specify brands for simple video capture devices. Might anyone have some advice or suggestions?
Thanks.
  2 个评论
Paul Sponagle
Paul Sponagle 2016-11-17
I have a similar problem. I want to be to take an RCA video input (NTSC) from any camera and manipulate in MATLAB. I have an Elgato USB video capture device, but it doesn't look like MATLAB supports it. Elgato support were not helpful as they said their device must use their software.
Mac solution is preferred, but PC will work too.
XING HU
XING HU 2017-3-10
Hi, my frame grabber is V.TOP External USB Video/Audio Capture Card. how do you solve your problem finally? thanks

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

Image Analyst
Image Analyst 2013-4-24
I use a simple Logitech webcam with ease. It's inexpensive.
  4 个评论
显示 2更早的评论
Clay
Clay 2013-4-24
I do not have an image capture device which transfers the analog signal to the PC.
Image Analyst
Image Analyst 2013-4-25
By "image capture device" you mean a frame grabber board, not a camera? So you already have some particular camera that you must use? And it's not a supported one that uses a standard interface like firewire or USB? And you need to use one of the supported frame grabber boards to grab frames from that camera? If so, have you contacted the supported frame grabber board manufacturers to see if they can capture your device's signal?

请先登录，再进行评论。

Walter Roberson
Walter Roberson 2013-4-24
Is the input source NTSC or PAL, or something else?
Maybe you could use osprey 100 at about $US170
  2 个评论
Clay
Clay 2013-4-24
The imaging device is a Sony XC-ST50 CCD camera. The output of the camera is coaxial which I can convert to VGA or RCA, so perhaps the osprey would work? Also, is the Osprey supported by the toolbox? I do not see it in the list of manufacturers.
Walter Roberson
Walter Roberson 2013-4-24
I got side-tracked looking for something affordable, as the prices I was finding for the known supported devices are around $US1900 - $US2300.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 National Instruments Frame Grabbers 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by