How to get the desired frequency in simplified synchronous machine?

7 次查看（过去 30 天）
chethan
chethan 2013-5-4
Hello,
when i simulate the model using simplified synchronous machine the output frequency is not proper. The parameters which i am supposed to use to get a frequency of 400Hz is N=6000(the input to the model is 628rad/s), pole pairs=4. when i give this parameter i don't get a freq of 400Hz, why is this? is there any other parameters that i have to change? if so please help me.
  8 个评论
显示 6更早的评论
chethan
chethan 2013-5-6
sorry, i don't know how to upload the pic here. and my simulation is very simple. i have a simplified generator connected to the RLC load. and for an electrical engineer the above given information is enough for him to just build the model in less than 2min. i thought you would do tat and give some useful solution. Anyways thanks Robert :) thanks for your consideration.
syed zia
syed zia 2013-5-23
I also need da same thing ,want to measure the frequency...and its variation after increasing load.........plz help me tnx....

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

John Doe
John Doe 2013-5-6
编辑：John Doe 2013-5-6
The electrical frequency is, as stated in the comments:
f_elec = poles * f_mec / 2
I was wondering what you were doing, because I can't see where you get in trouble. In a synchronous machine, the output frequency is only a function of the number of poles, and the rotor frequency, nothing else.
Since I don't know how you achieved 0.153Hz, I asked to see your model, so that I could try to figure out where your error is.
Thus, the answer to your question: "Is there any other parameters that i have to change?" is No, nothing else must be changed.
Best of luck!

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Machines 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by