How create serial RLC circuit in Simulink?

3 次查看（过去 30 天）
Filip Výmola
Filip Výmola 2013-5-9
Hi, I have small problem. I do serial RLC circuit in Simulink. I created scheme, have defined constat (capacitor, coil and resistor), but it isn't work. Output waveform isn't correct. Maybe I have wrongly set the source. There are equation, scheme and values:
Values: L = 0.3; C = 4*10^-5; R = 2 Source: Amplitude 20V; Frequency: 50 Hz
How set the source to the correct output? My output is here:

请先登录，再回答此问题。

回答（1 个）

John Doe
John Doe 2013-5-9
编辑：John Doe 2013-5-9
It looks as though your intial conditions are 0 for both integrators.
Are you supposed to simulate the system in steady-state? One of your initial values are probably incorrect. Are you given any additional information in your assignment?
(I haven't tried it out, but try setting the intial current to 0.0603). It is almost 90 degrees out of phase with the voltage
current = V/(R+1i*2*pi*f-1i/(2*pi*f*C)); % In steady state (as phasor).
- Rob

类别

在 Help Center 和 File Exchange 中查找有关 Circuits and Systems 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by