Compare two datasets of different units

6 次查看（过去 30 天）
Amanda Eriksson
Amanda Eriksson 2021-3-2
编辑： Veronica Taurino 2021-3-4
So I have two datasets
Set 1 contains values stored as 575x1 double, in the unit of kBq/cc, it is measured each half second
Set 2 contains values stored as 487x1 double, in the unit if Bq, it is stored each whole second
I want to plot them in the same figure to compare the two sets, but due to there being a order shift, the second set of data is much larger than the first set.
How can I find a calibration factor/coefficient that maybe I can use to make the second set in the same units as the first set (i.e make Bq to kBq/cc)?
I was thinking about a regression analysis, but I do not really know if the R I get from set 1 acutally is just to multiply with set 2 and it gives the right unit. I am really out on deep water and unsure of what to do.
I will post the three plots I've made so it will be easier to visualize the data

请先登录，再回答此问题。

采纳的回答

Veronica Taurino
Veronica Taurino 2021-3-2
编辑：Veronica Taurino 2021-3-2
You could just plot them in one figure with two axes:
Create Chart with Two y-Axes - MATLAB & Simulink - MathWorks Italia
  4 个评论
显示 2更早的评论
Amanda Eriksson
Amanda Eriksson 2021-3-4
Yes, I am comparing two blood sampling devices (they detect the true coincidences that happens when radioactivity decays, within the drawn blood). But instrument 1 is calibrated so that we get the measurement in kBq/cc, while for instrument 2 it only give out in Bq, thus we need a calibrationfactor. Usually when performing this onto patients, we take the catheter and measures it in a well counter. But this measurement above is simply done with saline and a radiotracer FDG, so the catheter wasn't measured in a well counter.
And I thought that maybe in someway it would be possible to find a calibrationfactor between the two by comparing them, but maybe that isn't possible. Very unsure, but thank you!
Veronica Taurino
Veronica Taurino 2021-3-4
编辑：Veronica Taurino 2021-3-4
I get it better know. Maybe you already know it but try checking with the instrument producer, they should provide some calibration factors.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Fit Postprocessing 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by