Syntax Error with if statement expression block

7 次查看(过去 30 天)
I am trying to read the queried data from a serial COM port using Instrument Query block from Instrument Control Toolbox, where the input being queried is supposed to be one character such as 'C'. I would like to use the queried data in an if-statement block such that if it's equal to a certain character, then the model connected to the output is enabled and runs. However, since the queried data is in ASCII format, I added ASCII to String block to do the conversion. Despite all that, I get a syntax error as shown in the figure below. Could the issue be in my If expression?

回答(1 个)

Shiva Kalyan Diwakaruni
Hi,
The 'If' block cannot accept a signal of type string.It supports only
Data Types: single | double | int8 | int16 | int32 | uint8 | uint16 | uint32
Instead you can use stringcompare block
or
compare to constant block
hope it helps,
thanks

类别

Help CenterFile Exchange 中查找有关 Sources 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by