NI PCI-6115 hardware support in matlab

2 次查看（过去 30 天）
phani
phani 2011-5-18
hi all, i am doing a project in which i want to acquire a signal with a sampling frequency of 10MHZ. to acquire the data with such a high sampling frequency i had chosen NI-PCI6115 module to capture the data i want to use this module with MAtlab. i want to know which version of matlab will support this module. in the link mentioned below it is said that matlab will support this module but i am using 2010b but i couldnt find the that this module is supported and i had seen all the other modules are supported by Matlab except "PCI-61xx" series.
any kind of suggestions are accepted please help me in this problem. thanks in advance
http://www.mathworks.in/products/daq/supportedio14005.html#PCI

请先登录，再回答此问题。

采纳的回答

Arnaud Miege
Arnaud Miege 2011-5-18
The web page you mention indicates that this particular board has been supported by the Data Acquisition Toolbox since R14SP3, so R2010b should be no problem at all. Do you have the Data Acquisition Toolbox? Also, it requires the drivers from NI-DAQmx, have you installed those? What output do you get when you use the daqhwinfo function? Does the board get detected?
HTH,
Arnaud
  5 个评论
显示 3更早的评论
phani
phani 2011-5-19
dear Miege
i had tried the suggestions given by you, but still i am facing the same problem. my software is not detecting the NI hardware. if you had any other possible solutions with you please let me know. thanks for help.
Arnaud Miege
Arnaud Miege 2011-5-19
Your best bet is to contact technical support (see link provided in my previous comment)

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 National Instruments Frame Grabbers 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by