清空筛选条件
清空筛选条件

Is there a way to stop Simulink from going through a function block after the first time during a Simulation

3 次查看（过去 30 天）
Nicholas
Nicholas 2013-6-17
Hello,
I am trying to run a model in Simulink where I set some constant variables with values in the top heiarchy using MatLAB Function blocks. As the simulation continues through all of my blocks it goes back to the beginning function block and redefines everything. I am wondering if there is a way to run through the function block once and then ignore it as the simulation continues. Any help and/or advice on this matter would be greatly appreciated. Thank you!

请先登录，再回答此问题。

采纳的回答

Azzi Abdelmalek
Azzi Abdelmalek 2013-6-17
You can use enabled-subsystems

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by