Issue to compile MATLAB embedded code in R2013a

1 次查看（过去 30 天）
Luca Barbiero
Luca Barbiero 2013-7-6
I have a Simulink model with some MATLAB function blocks in it. I did it using R2012a.
However, the model doesn't compile under R2013a. It says that it can't find any C compiler, which is needed for MATLAB Coder. I added the C compiler of MS Visual Studio 2012, using mex -setup, but the error remains.
Is there any known issue about this?
Also the Model Advisor gives an error, telling something about substituting the blocks with the ones of R2013a, but I didn't understand if that is referrend to the MATLAB functin bloks. I hope I don't have to redo ex-novo the whole model.
Note that all of this applies notwithstanding I saver the model in the new format .slx, as the advisor told me to do. Thanks, Luca

请先登录，再回答此问题。

采纳的回答

Ken Atwell
Ken Atwell 2013-7-6
The support for Visual Studio 2012 was incomplete in R2013a -- see this support solution for a patch. Let us know if this addresses your issue or not.
  4 个评论
显示 2更早的评论
Ken Atwell
Ken Atwell 2013-7-11
Muneer, that is a complete unrelated problem. I would create a new thread so many more people will see it.
Luca Barbiero
Luca Barbiero 2013-7-12
Yes, The Patch fixed the problem. I can now run the model with no further issues. Thanks again!

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Fixed-Point Designer 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by