清空筛选条件
清空筛选条件

Converting Analog Filter into Digital Filter

22 次查看（过去 30 天）
Royi Avital
Royi Avital 2011-5-25
Hello. I'm trying to design a simple Digital Filter. The transfer function of the filter is: 1 / s + alpha Where 'alpha' is a parameter (0.2).
Hence the Cutoff frequency is 0.2Hz.
I use the following code:
alpha = 0.2;
fs = 200; % Sample Frequency [Hz]
% Laplace Domain
B = 1;
A = [1, alpha];
w = 0:0.2:(fs / 2);
h = freqs(B, A, w);
figure;
plot(w, abs(h .* conj(h)));
% Digital Filter
[b, a] = bilinear(B, A, fs);
figure;
freqz(b, a, 1000);
As you can see, in the Freqs plot it works well. the Cutoff frequency is indeed 0.2Hz.
Yet it's not in the Digital Filter.
I tried using 'impinvar' as well with the same results.
How can I design the most accurate digital equivalent of this filter?
I'm using MATLAB R2011a.
Thanks.

请先登录，再回答此问题。

采纳的回答

Arnaud Miege
Arnaud Miege 2011-5-26
sys_cont = tf(B,A);
sys_disc = c2d(sys_cont,1/fs);
bode(sys_cont,sys_disc,w);
HTH,
Arnaud

更多回答（2 个）

Arturo Moncada-Torres

Your question is too wide, since there are a lot of digital filters that could behave they way you describe. Try using the Filter Design Analysis Tool. Just type

fdatool

It is very easy to use and you can export your results to an mfile so you can use it in your code. Hope it helps!

  1 个评论
Royi Avital
Royi Avital 2011-5-25
Hello,
I'm just looking for the reason the cutoff has changed?
I want to simulate the analog filter I described as good as possible.
For that matter the sampling frequency could get as high as 4800Hz.
Thanks.

请先登录，再进行评论。

Honglei Chen
Honglei Chen 2011-5-26
Hi Royi,
When you use Bilinear transform to convert an analog filter to a digital filter, you need to consider the effect of frequency warping. You can find this information in almost any DSP book such as Oppenheim&Schafer. Basically, if you want your digital filter to have a cutoff frequency at 0.2 Hz, then your analog filter needs to have a corresponding cuttoff frequency before the frequency warping.
HTH.
  1 个评论
Royi Avital
Royi Avital 2011-5-26
First, since the Sampling Frequency >> Cutoff Frequency the transformation is linear up to MATLAB accuracy.
Moreover, if I use 'impinvar' I get the same result, hence that's not the case.
I should have emphasized the target of the conversion between the analog filter and the digital:
Simulating colored noise.
My question is, how do I simulate this analog filter using MATLAB in order to color White Noise.
Thanks.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Analog Filters 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by