Simulink RF Blockset: How do I specify the frequencies (ωRF + ωLO) for a mixer within the configuration tab?

2 次查看（过去 30 天）
Philip Masters
Philip Masters 2021-5-2
编辑： Philip Masters 2021-5-2
So I'm building a little project with the end goal of simulating and displaying the result of a simple radar.
This is it so far:
As you can see I have a 1GHz signal which then 'splits into two' and one has a frequency offset added to it of 0.8GHz. So Import after the offset has a carrier frequency of 1.8GHz. And the signal without the offset has an Import1 block with carrier frequency 1GHz. These look fine in their respective scopes, but after the mixer I get this output in the Real Passband Scope1:
And this in the spectrum analyzer:
Which to me looks wrong as I;m not entirely sure why the peaks are at 1 and -1 after the offset at mixing. So, I assumed I hadn't specified (ωRF + ωLO) correctly within the RFConfig box as this uses the fundamental frequencies 1GHz and 1.8GHz whilst ωRF + ωLO = 2.8GHz or ωRF - ωLO = 0.8GHz. However, when I try to specify these frequencies manually under the Fundamental tones in the RFConfig to [0.8 2.8] I can't run the simulation and when I try [0.8 1 1.8 2.8] I get a 'too many carriers' error.
Does anyone know if I'm specifying these correctly and if not how I can go about doing that? If not, any suggestions would be grand, particularly going about testing the signals within the RF system as I can only see these signals once they're no longer within the RF system.

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Circuit Envelope Simulation 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by