Export meshdata and solution from pdetool
7 次查看(过去 30 天)
显示 更早的评论
I need to run the pdetool analysis several times for different values of pde coefficients. Repeating this procedure for different meshes is not convenient using the pdetool GUI.
Is there a way to automate the whole process via a .m file? The .m file should read the pde coefficients via the Matlab command prompt and should return the mesh (p, e, t) and solution (u) after the pde solution is complete.
Appreciate help in advance.
0 个评论
回答(1 个)
Deepak Ramaswamy
2013-7-19
编辑:Deepak Ramaswamy
2013-7-19
If I understood correctly, the geometry does not change and only the pde coefficients change. If this is the case, I would recommend a one-time exporting of the mesh and the BCs from pdetool and saving it to disk. Then, rather than go through pdetool for defining coefficients, using the command-line function: assempde/parabolic/hyperolic, programmatically enter coefficients and solve. Of course you will also need to load the mesh and BCs from the matfile that you've saved to prior. This way you need to use pdetool exactly once.
HTH
Deepak
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Geometry and Mesh 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!