清空筛选条件
清空筛选条件

Neural network working properly on Matlab but not in Simulink

10 次查看（过去 30 天）
Haritz Odriozola Olalde
评论： Kanchan Jha 2023-7-11
Hello,
I have trained a NARX type neural network using the NNTOOL tool and when I simulate the network for a given input in Matlab using the command
output=sim(net,input)
I get a satisfactory result.
The problem is that when transferring the network to Simulink using the command
gensim(net,ts)
I obtain a model that does not give good results in Simulink, the output signals being very different from what they should be.
What am I doing wrong when transferring the net to a Simulink block so it doesn't work well ?
Thanks in advance.

请先登录，再回答此问题。

回答（1 个）

Tarunbir Gambhir
Tarunbir Gambhir 2021-5-25
Please see the documentation page for gensim. When giving a parameter for 'SampleTime', its value may be -1 or any integer greater or equal to 1. However, this may override the default sample time of the trained model and lead to differences in the simulation result.
If you explicitly define the sample time, you should be able to see exactly the same output from MATLAB and Simulink.
  2 个评论
Haritz Odriozola Olalde
Haritz Odriozola Olalde 2021-6-8
Hi Tarunbir,
I have read the gensim documentation page and it does not appear anywhere that the sampling time must be an integer. In fact, we have tried entering st=0.00025 and it works. Still, we have found where the problem was, so thank you very much for your answer.
Regards
akram
akram 2023-2-18
Hello, I have exactely the same problem, did you find the solution ?

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Sequence and Numeric Feature Data Workflows 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by