Proper way to use op-amp in SimPowerSystems

4 次查看（过去 30 天）
Kunji
Kunji 2013-8-16
回答： Haoyu 2013-11-16
Hi,
I want to use op-amp in simpower systems but I can't seem to make it work. I've read from one forum to use an adder and connect it to a gain block then using s-ps converter, but still simulink won't let me connect the s-ps block to the simpower block.
You can check out the screenshot below: http://i1302.photobucket.com/albums/ag127/renguoma/attemptedop_zps138c469f.jpg
I know this is very simple but I really can't find any other solutions out there. Please help. Thanks.
  1 个评论
Kunji
Kunji 2013-8-27
i hope it's ok to bump this thread again, but I still haven't found any solution :(

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Haoyu
Haoyu 2013-11-16
Just remove S-PS block. It would work since all signals are within the PS signal.

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by