How do I get back filtered data using 'filter' after after getting the digital filter from bandpass?

1 次查看（过去 30 天）
Ikmal Rosli
Ikmal Rosli 2021-6-11
编辑： Chunru 2021-6-11
Hello everyone, I'm trying to figure out the bandpass and filter function, which I am using to filter out signals in the range of 1.9 to 4.1 from my data. My code below is based on the documentation. Basically, after getting the digital filter, d, from bandpass(), I tried using filter to get back the filtered signals, but I cannot seem to get the same output as from when using bandpass. Thank you in advance!
load data
fs = 24;
figure
bandpass(data,[1.9 4.1],fs)
[~, d] = bandpass(data,[1.9 4.1],fs);
figure
plot(filter(d, data))
[~, d] = bandpass(x,[100 200],fs);
figure
plot(filter(d, data))

请先登录，再回答此问题。

采纳的回答

Chunru
Chunru 2021-6-11
编辑：Chunru 2021-6-11
Ran in:
% load data
data = randn(512, 1);
fs = 24;
figure
% design filter, filter the data, plot the results
bandpass(data,[1.9 4.1],fs)
% desing the filter only
[~, d] = bandpass(data,[1.9 4.1],fs);
% filter the data using the filter object. (bandpass use filtfilt
% internally by default)
xf = filtfilt(d, data);
% compare the origninal and the filtered signal
t =(0:length(data)-1)/fs;
figure
plot(t, data, 'b', t, xf, 'r');
legend('Original', 'Filtered');
  2 个评论
Chunru
Chunru 2021-6-11
编辑：Chunru 2021-6-11
Hi. The question is not dumb. :-).
You can search document, eg. doc bandpass
Many matlab function has source code. You can edit bandpass. Then you can debug the program by stepping through.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Filter Analysis 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by