Error in PWM Generator Vienna Rectifier

2 次查看(过去 30 天)
Expected a value representable in the C type 'int'. Found 5.000060 instead. Error in 'test/PWM Generator (Vienna Rectifier)/Gate Signal Generator/Signal Correction' (line 4) switch SmallHexNum
I am getting this error and hence cannot linearize my model to find transfer function and hence desgin PI controllers for it.

回答(2 个)

Mohamad Nazir
Mohamad Nazir 2021-6-11
Have you tried to simply insert a "round" block or a "data type conversion" block (or maybe both) for "SmallJexNum" in the "PWM Generator (Vienna Rectifier)" block between the "Switching Time Calculation" block and "Gate Signal Generator" subsystem in order to see if that resolves this error?
In case it does you might get the error that is causing this problem in the first case or no errors so you could run the simulation in order to investigate more (I'd start by observing Iabc and checking the switching period notably)
  1 个评论
Arkadeep Deb
Arkadeep Deb 2021-6-11
编辑:Arkadeep Deb 2021-6-11
I cannot insert any block between switching time calculation and gate signal. They are non-editable.
Can I get your email address please, I want to discuss this issue with you in detail.

请先登录,再进行评论。


Dr. Pemendra Kumar Pardhi
Please used datatype conversion with boolean in place of intiger 8 (int 8)
I think it may creat a problems.
  1 个评论
Arkadeep Deb
Arkadeep Deb 2021-6-11
the simulation is running, however, when I try to tune the PID controller I get this error. Hence cannot get the bode plot. As you mentioned to use boolean data type, the problem lies inside the PWM generator block which I cannot change. I will upload the simulation file in my question, if you can help me tune the PI controller.

请先登录,再进行评论。

社区

更多回答在  Power Electronics Control

类别

Help CenterFile Exchange 中查找有关 Nonlinear Operators 的更多信息

产品


版本

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by